SAFETY PRECAUTIONS
• Do not install the drive pinion on the motor when you test the ESC and
motor for the first time to verify the correct settings on your radio. Only
install the pinion after you have confirmed that the settings on your radio
is correct.
• Never use ruptured or punctured battery cells.
• Never use battery packs that are known to overheat.
• Never short circuit battery or motor terminals.
• Always use proper insulation material for cable insulation.
• Always use proper cable connectors.
• Do not exceed the number of cells or servos specified for the ESC.
• Wrong battery polarity will damage the ESC and void the warranty.
• Install the ESC in a suitable location with adequate ventilation for cooling.
• Use only batteries that are supported by the ESC and ensure the correct
polarity before connecting.
• Switch your transmitter ON first and ensure the throttle stick is in the mini-
mum position before connecting the battery pack.
• Never switch your transmitter OFF while the battery is connected to your
ESC.
• Only connect your battery pack just before flying and do not leave your
battery pack connected after flying.
• Handle your model with extreme care once the battery pack is connected
and keep away from the propeller at all times. Never stand in-line or direct-
ly in front of any rotating parts.
• Do not immerse the ESC under water, do not allow it to get wet while pow-
ered up.
• Always fly at a designated flying site and follow the rules and guidelines set
by your modeller’s club.
Recycling and Waste Disposal Note (European Union)
Electrical/electronic equipment marked with the crossed-out waste bin symbol must not be discarded in the domestic waste; it should be disposed off via
the appropriate specialised disposal system.
In the countries of the EU (European Union) electrical/electronic devices must not be discarded via the normal domestic waste system (WEEE - Waste of
Electrical and Electronic Equipment, Directive 2012/19/EU). You can take your unwanted equipment to your nearest public collection point or recycling cen-
tre, where it will be disposed of in the proper manner at no charge to you.
By disposing off your old equipment in a responsible manner you make an important contribution to the safeguarding of the environment!
EU Declaration of Conformity
Hereby, Zhongshan Langyu Model Co., Ltd. (OMP HOBBY) declares that this OMP HOBBY 85A brushless electronic speed controller is in compliance with the
essential requirements as laid down in the relevant European directives.
The full text of the EU Declaration of Conformity is available at www.kavanrc.com/doc/
Guarantee
The KAVAN Europe s.r.o. products are covered by a guarantee which fulfils the currently valid legal requirements in your country. If you wish to make a claim
under guarantee, please contact the retailer from whom you first purchased the equipment. The guarantee does not cover faults which were caused in the
following ways: crashes, improper use, incorrect connection, reversed polarity, maintenance work carried out late, incorrectly or not at all, or by unauthorised
personnel, use of other than genuine KAVAN Europe s.r.o. accessories, modifications or repairs which were not carried out by KAVAN Europe s.r.o. or an autho-
rised KAVAN Europe s.r.o., accidental or deliberate damage, defects caused by normal wear and tear, operation outside the Specification, or in conjunction
with equipment made by other manufacturers.
Please be sure to read the appropriate information sheets in the product documentation!
Made in China
