Operating Manual
18
Original Operating Manual
Replace worn sliding pieces (2) by removing nut (11) from each cylinder (10). Pull the
arms to the side to remove (see Chapter 3.2). Remove the screw (4). Replace the
sliders (2). When installing the new sliders, make sure that the axial stops (5) are
correctly seated (5). Remount the screw (4). Push the arms into the slides (9) and
remount the cylinder (10) nuts (11).
Replace defective supporting rollers (24) in the hooks (23) by removing the screws
(22). Using suitable hoisting gear tilt the clamp body (8) forwards away from the fork
carriage on the lift truck. Remove the bolts (25) in the hooks (23), remove the defective
supporting rollers (24) and replace them with new ones. Remount the clamp body (8) in
the reverse order.
After installing or removing a cylinder (7, 10), always check the clearance between the
cylinder mount (17) and nut (6, 11) of the cylinder (7, 10). Cylinders are installed with
axial clearance of 1.5 to 2 mm.
Renew defective pins (14) by removing the bolts (13) and retaining ring (15). Mount the
new pins (14) and then the retaining ring (15) and bolts (13). Make the adjustment of
the arm pre-load in accordance with section 6.3.5. Only replace the pins (14) in pairs.
6.3.3 Clamping arms, model T 413GT and model T 413GT-1L
As necessary
Replace the
worn rubber covering (1).
worn bars (2, 4) by removing the screws (3, 5).
