w w w . k a u b e r . e u
ver1.0
is going to be memorized. The LED indicator will flash a few times to confirm the operation and exit the mode.
The maximum time to memorize is 255 seconds.
5) Switching off the countdown for the unfolding time
When the countdown for the unfolding time is switched off, the seconds are not counted and the direction of
unfolding is toggled permanently or until the “STOP” button is pressed on the remote or button switch. Push the
programming button located in the centre of the module
7
times. After about 2 seconds the LED indicator will
flash
7
times confirming that the function is set.
6) Switching off the countdown for the folding time
When the countdown for the folding time is switched off, the seconds are not counted and the direction of folding
is toggled permanently or until the “STOP” button is pressed on the remote or button switch. Push the
programming button located in the centre of the module
8
times. After about 2 seconds the LED indicator will
flash
8
times confirming that the function is set.
7) Programming the method of functioning of the button switch input
a) STABLE MODE
The engine output is switched on for the duration of holding the button on the switch. Push the programming
button located in the centre of the module
9
times. After about 2 seconds the LED indicator will flash
9
times
confirming that the function is set.
The module is set to the stable mode by default.
b) TEMPORARY MODE
– method I
Temporary pressing the button switch triggers the output of the engine for the duration that was previously
programmed. Push the programming button located in the centre of the module
10
times. After about 2
seconds the LED indicator will flash
10
times confirming that the function is set.
c) TEMPORARY MODE
– method II
Temporary pressing the button switch triggers the output of the engine for the duration that was previously
programmed. Additionally, every second pressing of the button issues the “STOP” command. Thanks to this
function, when using the double button switch we also have the ability to stop the screen/elevator at any time.
Push the programming button located in the centre of the module
11
times. After about 2 seconds the LED
indicator will flash
11
times confirming that the function is set.
Caution: We can enter any of the funct
ions at any moment during the module’s functioning. If we want to make
adjustments to any of the parameters of the module, we can do this without the need to go through the whole procedure
of programming.
Technical specifications:
●
power supply
230V AC
●
the maximum current load
2,5A
●
power use on standby
0,5VA
Possible ways of controlling the module:
-
TRIGGER 12V output
-
two-position switch with/without the hold option
-
KAUBER remote control
