Operating the Receiver
13
Tone muting switch
•
Press this
button.
The tone will be muted, allowing you to telephone undisturbed.
•
Press this
button again, to restore the volume.
Important
The muting switch has no control over the VCR scart-socket.
Stereo / Mono Channel Switching
Transmissions may be recorded using the two channel system.
(e.g. Original English tone on channel 1, German tone on channel 2).
•
Press this
button to step through the tone options:
Stereo
→
Channel 1
→
Channel 2
→
Stereo
•
The selected channel will be shown on the screen.
The selection will not be saved. After switching programs the original setting will be
restored.
Video Recorder - Replay (VCR)
To use ”VCR-Replay”, the receiver must be switched on, then the signal path will
be automatically switched through from the VCR scart-socket to the TV scart-
socket.
SAT/TV Switching
When a satellite-receiver and a TV are connected with a single scart-cable, many
TVs will switch the signal input over to video mode (at the scart-socket) immedi-
ately the satellite receiver is switched on. The switching voltage must be turned off
at the scart-socket if you want to watch a terrestrial TV transmission.
•
Press this
button.
The switching voltage on pin 8 of the scart-socket will be switched off, and may be
switched back on by pressing the same button again.
In SAT mode, ”SAT mode” will be displayed on the screen for approx. 3 seconds.
Operating the Receiver without a Remote Control
When the satellite-receiver is switched on it will automatically return to the mode it
was in before it was switched off.
If the receiver was in ”
Stand-by
” mode when it was switched off at the mains, it will
automatically return to the ”
Stand-by
” mode when switched on again. If you have
miss-placed the remote control, you can switch the receiver back into the receiving
mode by pressing both buttons
on the front side simultaneously.
By pressing both switches again you can switch between ”
TV
,
analog and ADR
radio
” modes.
