RECEIVER OPERATION
13
The extensive equipping of this receiver permits
reception of digital DMX pay-radio programs (with
a card), free digital ADR radio programs and also
analog satellite radio programs.
In the operating description that follows it is as-
sumed that the receiver has already been properly
connected up by a competent specialist. If this is
not the case, and you intend setting up the con-
nections yourself, please read the section "Con-
nection and Start-up" beforehand.
Switching the unit on
Switch the unit on via the power switch
on the
unit. The most recently selected program mode
appears (DMX-, ADR- or Analog radio) together
with the last selected program position. If the unit
was in standby mode before being switched off, it
returns again to standby mode when it is switched
on via the power switch. The unit is switched be-
tween standby and in-operation via the
key on
the remote control handset.
Program selection
The receiver offers the user a variety of program
selection possibilities:
There is a choice from:
•
120 DMX Pay-radio program positions
(with a DMX smart card)
•
100 ADR Radio program positions
(free radio programs)
•
100 Analog radio program positions
The ADR- and DMX-programs are transmitted
digitally, i.e. almost in CD quality.
The transmission of analog radio programs is car-
ried out using the well-known "Wegener Panda 1"
standard.
The switch-over to the individual regions takes
place using the "DMX"-"ADR"-"RADIO" keys on
the remote control handset.
Program selection in the respective regions is pos-
sible via the numeric keys (0...9) and the
keys on the remote control handset and on the
unit.
Digital radio reception
a) DMX-Radio Pay-radio programs
Display readout: D..
To receive DMX pay-radio programs, insert the
smart card into the card slot on the receiver in
the direction of the arrow (micro-chip on the un-
derside).
Press the DMX key.
The program number, program name and pro-
gram category assigned to the program appear
in the two-line LCD display.
If you have forgotten to insert the card or you
have not inserted it correctly the following mes-
sage appears:
ATTENTION:
PLEASE INSERT CARD
The sound is not cleared.
Check that you have inserted the card correctly.
In DMX mode, the only valid DMX program
numbers are those established by the program
supplier that are also included in the transmis-
sion. These are shown in the LCD display.
A change in the predefined numbering is
therefore not possible in DMX mode.
(refer to Favorite mode however)
After approximately 3 seconds information
about the title, artist, album, author and CD No.
is faded-in alternately (TTA-data).
b) ADR-radio reception (free radio programs)
Display readout: A..
Press the ADR key
The station name, program number and cate-
gory designation of the most recently selected
program appear in the display.
In the case of ADR programs, aside from the
station and category designation, there can also
be additional information transmitted (radio text
and other info.). These are then also shown in
the LCD display (see also Display Info.).
Note:
The displays and fade-ins only appear if they
are also sent by the program supplier.
If no information is transmitted, the message
"No Data" appears.
