2 / 8
Safety Instructions
The UAS 582 feed system may only be mounted to the listed Kathrein parabolic antennas. The feed
system is subject to the same safety and danger warnings as listed in the instructions for using of
fset parabolic antennas. Please follow these instructions at all times, as otherwise you or other
people may be exposed to danger (electric shock through overhead lines, risk of falling down, falling
parts, thunderstorm etc.).
Mounting and Connection of the feed system
Fixing the feed system (Fig. 1)
1. Position the feed system as desired on the multifeed
plate at the end of the bracket (see antenna instruc-
tions)
2. Fasten the feed system on the front part using the
Allen wrench (torque: 4.5 Nm).
All fastening and tightening can be effected
with the supplied Allen wrench (SW4).
Hier ansetzen
M
A
= 4,5 Nm
Setting the polarisation (Fig. 2)
See the value in the table Tab. 1, S. 5 for the polarisa-
tion setting.
If the value differs from the pre-set 0°, proceed as follows:
1. Loosen both Allen screws (S).
2. Turn the feed system to set the reference mark to the
value given in the polarisation pre-setting table.
3. Tighten the Allen screws (S) evenly, alternating
between both.
Torque: max. 4.5 Nm
Polarisation 0°
Polari15°
Polarisation -15°
Allen screw (S)
Fig. 1: Fixing the feed system
Fig. 2: Setting the polarisation
