background image

 

 

 

 

 

 

 

 

 

Page 7   

 

 

 

 

 

 

 

5.

 

Safety and Recommendations 

 

WARNING:

  The  Compensator  unit is designed  for in-car use only. It MUST  be well 

integrated into the automotive environment (T

ambient

 max. 85 °C) and should be 

installed by the  OEM (car-manufacturer)  or in case of replacement by a 

professional garage.  

WARNING:  

Only the antennas listed at the Antenna Kitting section are allowed to be used 

along with the Compensator. The use of other antennas will cause the cease 

of the Compensator´s operating license. 

RF SAFETY WARNING:

  Any antenna used with this device must be located at least  

8 inches (20,3 cm) from all persons. The FCC requires that a cell phone with 

cradle attached may only be used with the in-car mounted cradle. It is not 

allowed to use a cell phone with an attached cradle near to the ear. 

WARNING:

  The Outside Car-Antenna must be installed no higher than 10 meters above 

ground. 

 

This is a CONSUMER device 

BEFORE USE

, you 

MUST REGISTER THIS DEVICE

 with your wireless provider and have 

your provider´s consent. Most wireless providers consent to the use of Compensators. Some 
providers may not consent to the use of this device on their network. If you are unsure, contact your 
provider.  
In Canada, 

BEFORE USE

 you must meet all requirements set out in ISED CPC-2-1-05. 

You 

MUST

 operate this device with approved antennas and cables as specified by the manufacturer. 

Antennas 

MUST NOT

 be installed within 20 cm of any person.  

You 

MUST

 cease operating this device immediately if requested by the FCC (or ISED in Canada) or 

a licensed wireless service provider.  

WARNING

 E911 location information may not be provided or may be inaccurate for calls served by 

using this device. 

 

 

 

This device complies with Part 15 of FCC rules. Operation is subject to two conditions: 

1)

 

This device may not cause harmful interference. 

2)

 

This device must accept any interference received, including interference that may 

cause undesired operation. 

Changes or modifications not expressly approved by KATHREIN Automotive could void the 

authority to operate this equipment. 

 

 

Summary of Contents for LTECOMPB1









Reviews: