Kathrein EXIP 4124, Manual

Page: 13 / 16

5 / 8
Rear View
1 2
8 7
6
5 4 3
Fig. 3: EXIP 4124: Back panel
No. Function
①
Stream LED
②
Power LED
③
RF1 input
V
in wideband mode; single-cable connection (EN 50494 and EN 50607)
④
RF2 input
H
in wideband mode
⑤
10/100/1000-MBit Ethernet connection
⑥
Reset button
⑦
On/Off switch
⑧
Power supply connection (12 V/4 A)
Connecting the Device
Connecting the EXIP 4124 to a Single-cable Multi-switch/Single-cable LNB
1. Connect RF1 input to a single-cable multi-switch or single-cable LNB.
2. Connect the device to a router with an Ethernet cable. Normally, the existing router
(e.g. FRITZ!Box) will automatically assign an IP address.
3. Connect the power supply unit to the EXIP 4124.
4. Connect the power supply unit to the mains voltage.
5. Switch on the device.
➯
The Power LED lights up. Connection to the network is being established. When
the network is connected, the blue Stream LED lights up.
The default setting for LNB Settings is OneCable . If the EXIP 4124 is connected to an
EN 50607 (SCD2)-capable device, no further settings are required.
If the EXIP 4124 is connected to a device that only supports the EN 50494 standard:
●
Select OneCable under LNB Settings in the web interface, see Operating the Web Inter-
face, p. 6.
●
Enter the corresponding user band frequencies, see Instructions for the Web User
Interface for the EXIP 4124.