3 / 8
Safety Instructions
Danger to life from electric shock and fi re hazard due to electric current!
Tampering with the unit may jeopardise its electrical safety. The manufacturer
accepts no liability for accidents caused by the user opening the unit. Opening the
unit and attempting to repair it yourself voids all warranty claims.
►
Do not open the devices or tamper with it.
►
When working on the system, always unplug the power supply from the wall socket.
►
Ensure adequate clearance. Clearance all round must be at least 5 cm. Make sure
there is free circulation of air to dissipate the heat from the unit.
►
Operate the devices in the permissible ambient temperature range of 0 to +40 °C
only.
►
Pull the plug out of the mains socket to completely disconnect the device/power
supply unit from the mains.
►
To ensure isolation from the mains, the socket used must be freely accessible at all
times
►
Do not place any liquid-fi lled items on top of the devices.
►
Do not expose the devices to dripping or splashing water and install the device in
dry indoor areas only.
►
Do not install on or against highly combustible materials.
►
Make sure that the device is equipped with an equipotential bonding conductor
(Cu, at least 4 mm
2
).
►
Make sure to comply with the safety regulations set out in the current EN 60728-11
and EN 62368-1 standards.
Installation Instructions
►
Connectors for coax. cables: RF connectors 75 Ω (series F) according to EN 61169-
24.
►
Terminate unused F-type connectors with an EMK 05 (voltage-separated).
►
Fasteners for concrete substrates and masonry: 4 suitable plugs and associated
screws with half-round, countersunk or cylindrical head, outer thread diameter 4 - 6
mm, head diameter ≥ 8 mm, height of head ≤ 5 mm and a screw length ≥ 25 mm.
For other types of wall, use the appropriate screws or screw-dowel systems, which
offer the same or better fastening.
Risk of damage to property!
An inner cable conductor with a diameter greater than 1.2 mm, or the presence of burrs
may damage the device inputs/outputs beyond repair.
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
