3 / 12
●
The equipment described is designed solely for the installation of satel-
lite receiver systems.
●
Any other use or failure to comply with these instructions will void the
warranty or guarantee.
●
Install the equipment only in dry areas indoors. Do not install on or
against highly combustible materials.
●
Make sure that the equipment is provided with an earthing wire (Cu, at
least. 4 mm
2
).
●
Make sure to comply with the safety regulations set out in the current
EN 60728-11 and EN 60065 standards.
●
Fixings: Screws, max Ø: 4 mm
●
Connectors: RF connector 75 Ω (series F) according to EN 61169-24.
●
Terminate any unsused RF ports with 75 Ω resistors, e.g. EMK 03.
●
To meet EMC requirements, the only power supply unit allowed to be
used is the NCF 18.
Current-carrying device
●
Do not open the unit or temper with it.
●
When working on the system always unplug the power supply unit from
the wall socket
.
●
The device is intended only for wall mounting; see
(Symbolic Representation), p. 10
. All other installation positions are
prohibited.
●
Ensure adequate clearance to all sides of at least 5 cm.
●
Danger of overheating! Ensure that free circulation of air to discharge the
heat emitted by the unit is possible.
●
Operate the device only in the permissible ambient temperature range of
–20 to +55 °C.
Notice:
●
Do not place any liquid-filled items on top of the power supply unit.
●
Do not expose the power supply unit to dropping or splashing water.
●
Make sure that the power supply unit is easily accessible and operable.
●
Bear in mind that the only reliable method of disconnecting the unit from
the mains is to unplug it.
●
An inner cable conductor
diameter greater than 1.2
mm, or the presence of
burrs may damage the
sockets on the unit.
Max. 2 mm
excess
length
Tight-
ening torque
max. 3.4 Nm
(danger of over-
winding)
Diameter 0.6 – 1.2 mm
free of burrs
Installation and Safety Instructions
