29
Polarisation setting
To dismantle/install the planar antenna from the turntable, proceed as
follows: (the key names refer to the remote control for the UFD 170
receiver)
1. Turn on the receiver with the main switch on the front of the unit.
2. Press the Standby button (
) to start up the receiver.
3. First of all, “Welcome UFD 170” and you will then see the message
“Please wait, initialising HDP”.
4. Wait until you see the message “Astra position unknown,
press OK to start search mode” and cancel this operation with
the
button.
5. Next,
press
the
button to go to the main menu, use the
buttons to navigate to the option “HDP antenna setup” and con
fi
rm
your selection by pressing the
button.
6. Use the
buttons to select the Elevation option and use
the number keys on the remote control to enter “400”.
7. Press the
button and the turntable will move to the selected
elevation angle.
8. Turn off the UFD 170 using the main switch on the front and
disconnect it from the power.
9. Unscrew the antenna fastening screws on the turntable with a
suitable hexagon socket key (size 5), see photograph on left.
10. Carefully lift the antenna off the turntable and exchange the
slot for the rubber bushing with cable and the relevant dummy
bushing (depending on the direction you want to move the
antenna).
11. You can now re
fi
t the antenna with the desired change of angle
(+15° or -15°) (see picture below).
12. Tighten the hexagon socket screws to a torque of 6-7 Nm.
13. Leave the installation location and reconnect the UFD 170 to
the power supply.
14. Turn on the receiver,
fi
rst with the main switch and then with the
Standby button (
).
15. “Welcome UFD 170” appears.
16. You will then see the message “Please wait, initialising HDP”. Wait
until you see the message “Astra position unknown, press OK to
start search mode” and cancel this operation with the
button.
17. Change to the main menu with
, use the
button to
change to the “HDP antenna set-up" menu element, and con
fi
rm
with
. Use the
button to change to the “Reset/park”
menu element, change the selection to "Reset" with the buttons
and con
fi
rm with
. After the antenna has been reset, you can
return to the normal TV picture with the
button.
In motorhome/caravan
On the turntable
