16
en | Programming
LE80 Radio Receiver
LE80_UM_EN_V1.1_2021.12
User Manual
TeleAlarm
mode, the triggered transmitters can be received by the
LE80 only in the near distance
5.2.2
Mode indication after power on
When the power supply is connected to the LE80 Radio
Receiver, the LED 2 will blink 1 seconds in different colors,
the LED 1 will light up permanently for 2 seconds.
Afterwards, the device will display the current mode
through the LED, by blinking pink as many times as the
number of the mode. The green LED will then light up
permanently.
Example: In mode 8, the LED will blink pink 8 times.
5.3
Enter manual transmitter’s programming
mode
To enter manual transmitter’s programming mode, press
simply button T1 for one to three seconds. See button location
in
Section 4.1 Connecting ports, page 13.
5.4
Manual programming a transmitter in
modes 1, 2, 5, 8 or 9
NOTICE!
Before programming the transmitter must be programmed
to send radio messages to the LE80, or to both NurseCall
unit and LE80.
NOTICE!
Both relays will not be activated in the programming mode.
NOTICE!
Per manual programming sequence only one transmitter
can be matched. Up to 20 transmitters can be programmed.