19
5.
In the end, the screen shows the message: “Done !”
Done !
~ 008.0000 g
6.
Remove the dosed crucible.
7.
Wait for the message saying to Add the container before installing the next
one.
8.
If the same weight is used for the next dispensing, no further action will be
required than installing the crucible or the container.
Ratio mode
This mode will dispense the flux based on the selected ratio of Sample/Flux
(“relative” mode).
9.
Using the Left/Right/Up/Down arrows, set the needed ratio. (In our
example, we are using 1 g of sample to 8 g of flux)
Select Ratio:
1.00/08.0 ~
10.
Then, press Enter. The following screen will appear:
Add the
container
11.
Add the crucible which will be used for the weighing.
12.
Press Enter ; the pre-weighing of the flux will start.
Executing
pre-weighing
NOTE:
In the case of a non-stable environment, a difficulty to tare could occur.
In that case, cancel the process and restart it.
13.
After the pre-weighing, the instrument will record the actual amount of
dispensed flux, and then tare the balance, ready for the next step.
Add the
sample ~
