CORDLESS Hammer Drill INSTRUCTION MANUAL
CHARGE-ALL
4 • 6 • 8 • 10 • 12 • 14
18V
5
HOW TO INSERT A DRILL BIT
CHARGE-ALL
4 • 6 • 8 • 10 • 12 • 14
18V
*CLICK*
CHARGE-ALL
4 • 6 • 8 • 10 • 12 • 14
18V
Grab & Twist
clockwise
Drilling &
installing
Half way
= Locked
Undoing &
removing
Grab & Twist
Anti-clockwise
1. LOOSEN THE CHUCK
2. SET THE BIT
Holding the drill, place your hand on the keyless
chuck (1) and rotate in a clockwise direction.
You will notice the jaws of the chuck opening.
Once they are wide enough to insert drill bit, stop
rotating.
Make sure the smooth of the drill bit (the shank) is
facing the drill. This is the part that the chuck jaws
will hold. Insert the drill bit until it hits the end of the
chuck, and pull it back around 1cm.
3. TIGHTEN THE CHUCK
4. SET DRILL DIRECTION FOR USE
Holding the bit, place your hand on the chuck
and rotate in an anti-clockwise direction. You will
notice the jaws of the chuck closing on the drill bit.
Continue to tighten the chuck as tight as possible,
ensuring the bit is firmly secure. Rotate the chuck
in the opposite direction 1 click to place the chuck
in it’s operating position.
Set the forward/reverse button (4) to the desired
direction:
Push in from the left - Undoing and removing.
Push in from the right - Drilling and installing
220001
