4
1.2
Intended Applications
Only use the mobile Microfiltration System MOT-7 as well as any accompanying accessories /
components per
manufacturer’s instructions. Intended usage is discussed in these instructions.
In order to ensure the mobile Microfiltration System MOT-7 can perform the described level of
treatment, the parameters set out must be followed. In addition, the physical and chemical parameters
for drinking water as required by state-specific requirements for drinking water fit for human
consumption must also be adhered to.
The mobile Microfiltration System MOT-7 has been designed and built based on state-of-the-art
technology, in order to provide safe operation when safety regulations and operating requirements are
followed.
Working on the mobile Microfiltration System MOT-7 as well as operation and use of the
system is permitted only when the unit is in good condition technically and when attention
is paid to safety standards and to potential hazards as described in these operation
instructions, the handbook, as well as in this supplement.
Only when these are followed without exception can operators and others avoid the loss
of life and serious injuries or avoid interference with the
system’s operation or other
material assets.
Appropriately trained specialist must immediately repair malfunctions, damage, or resolve
abnormal operations that could compromise safety!
Safety gloves with sufficient protection must always be worn when performing any
maintenance on the mobile Microfiltration System MOT-7.
Always properly dispose of waste products, in particular fluids in the pump unit, at
designated locations or with specialists.
In order to avoid accidents and possible work disability resulting from accidents due to
improper operation of the Katadyn mobile Microfiltration System MOT-7, please
observe and follow pertinent safety procedures. Improper handling of the Katadyn
mobile Microfiltration System MOT-7 can put health at risk. Operating/handling duties
may only be performed by trained personnel.
Only open the filter chamber when it is unpressurized and emptied.
Before cleaning, maintenance, repair or replacement of parts, the hydraulic unit must first
be depressurized, and the pump unit turned off. These duties may only be performed by
trained personnel.
