Key Components
Float
Output Hose
Input Hose
Prefilter
(Figure 21)
Product Setup
The Mini requires minimal set up. For best results, try out the Mini before first field use to familiar
ize yourself with its operation.
1)
Connect Hoses
Remove the plastic caps from the input and output barbs; retain for storage. Connect input
hose (hose with prefilter) to input barb at base of pump housing. Connect out put hose to
out put barb on top of cartridge. Connect the EasyFill Bottle Adaptor to the end of the out
put hose. (Figures 11, 21, 22)
2)
Flush System
Important: Before first use, flush system by pumping approximately 0.5 litres of water
through the unit to remove harmless ceramic dust. See following section on Normal
Operation on how to filter water.
Normal Operation
1)
Place input hose in untreated water source. Adjust the float to keep prefilter off the bottom
and away from sediment.
2)
Place the output hose into a clean water container*. (Figure 22)
3)
Hold the filter vertically and begin pumping the handle in a slow, steady manner. Make sure
the input hose is not kinked.
X > Z
X > Z
Z
Z
X
X
-
(Figure 22)
(Figure 23)
Output Barb
Measuring
Gauge
Ceramic
Element
GB
