KASTOR KT-S-20, Installation And Operating Instructions Manual

Page: 36 / 84

EN
gl
ISH
TAblE Of cONTENTS
1. bEFORE YOU INSTALL
1.1. Package contents and its inspection
1.2. Important matters and regulations
1.2.1. Note during installation of insulation wool!
1.3. Heating wall piercing stoves
1.4. Installation of water tank VK-20
2. INSTALLATION AND PREPARATION FOR USE
2.1. Preparing for use and burn-in
2.2. Stones and their arrangement
2.3. Stove base
2.3.1. Installation on wooden floor with a cast concrete base
2.3.2. Installation on tiled and waterproof floor
2.4. Safety distances and protections
2.4.1. Safety distances
2.4.2. Reduction of safety distances
2.5. Connecting the stove to a brick chimney
2.5.1. Connecting from the top
2.6. Connecting to a Kastor chimney
2.7. The stove’s sauna side door and its use
2.8. Air guide plate
2.9. General damage prevention directions
3. USING THE STOVE
3.1. Fuel
3.2. Usage with VK-20 water tank
3.3. Adjusting the air flow
3.4. Adjusting the heat output
3.4.1. A sauna bath on just one load of wood, lighting from below
3.4.2. A sauna bath on just one load of wood, lighting from above
3.4.3. Continuing the heating with a second load
4. MAINTENANCE
4.1. Cleaning the stove
4.2. Ash removal
4.3. Sweeping the stove
4.4. Removal and cleaning of the KT-H model’s elevator door glass
4.5. Cleaning the glass on the stove door of the KT-S model
4.6. Cleaning the glass on the internal door of the KT-S and KT-H models
5. TROUbLESHOOTING
6. WARRANTY AND MANUFACTURER IDENTIFICATION
This installation manual was last updated on 30 October 2008.