Fig.7 Fig.8 Fig.9
B.
Fan blade
•
Install the fan blade through the fan blade position hole. Ensure the fan blade grooves fit the
motor shaft fixing pin and push in until it reaches the fixing pin (Fig 10).
•
Install the fan blade knob in anticlockwise direction onto the motor shaft until it is tightened.
Please hold the fan blade when installing the fan blade knob (Fig. 11).
OPERATION INSTRUCTION
1.
Power on / speed adjustment
•
Press fan speed button for speed adjustment
：
0:Off / Stop 1:Low Speed 2:Medium Speed 3:High Speed
Note: If the timer knob is turned to “OFF”, the fan is
turned off. Please ensure the timer knob is
turned to “ON” or selected time b
efore starting the operation.
2.
Timer
•
Turn the timer knob to “ON”
, the fan will be operated continuously, no auto off timer
setting.
•
Turn the timer knob to the number, which indicates the fan will stop after the set time
limit. For example, turning to 20 means the fan will be off after 20 minutes; Turn the
timer knob to “OFF”, the fan
will not operate.
3.
Oscillation
•
Press down the oscillation knob, the fan will operate in
oscillating mode to swing horizontally. Lift the knob to
stop the oscillation.
4.
Height adjustment
•
Turn off the fan, then hold the height adjustment pole and
loosen the height adjustment ring, then adjust the pole to
the required height and tighten the height adjustment ring
by twisting it in clockwise direction.
5.
Angle adjustment
•
Turn off the fan, then lift or press the motor lightly to adjust the
blowing angle.
MAINTENANCE INSTRUCTION
Attention:
•
Please turn off and unplug the appliance before cleaning or maintenance.
•
Clean the surface of the appliance with a dry cloth.
•
Do not use corrosive detergent or solvent to clean the appliance to avoid any discolouration or
damage.
•
Do not swash with water.
•
Do not use hard objects to clean the fan.
•
Regular cleaning is suggested to avoid dirt blockage that may result in mechanical failure.
position
poles
Guard knob
Motor shaft
fixing pi
n
Motor
shaft
Fan blade
position hole
Fan
blade
groove
Timer
Knob
Twist in
clockwise
direction
-5-
Fan speed button
Oscillation knob
-6-
-7-
2.
Guard and fan blades installation
A.
Rear guard
•
Unscrew the fan blade knob from the motor shaft in clockwise direction (Fig. 7).
•
Unscrew the guard knob from the motor shaft in anticlockwise direction (Fig. 8).
•
Set the rear guard and fit it well on the three position poles and make sure these poles are
properly put through the holes on the rear guard. Hold the rear guard and tighten the guard
knob in clockwise direction on the motor shaft (Fig. 9) .
C.
Front guard
•
Normally, the guard ring is installed with the front guard. Loosen the screw on the bottom of
the guard and fit the front guard with guard ring into the rear guard. After that, lock the guard
clip and tighten the screw (Fig.12).
Fig.10 Fig.11
Fig.
12
Guard clip
