5
OPERATION INSTRUCTION
Power Switch
Connect the power plug to the correct socket outlet.
Press the power switch to the “
I
” position, you will hear a “beep” sound, and the LED display will be
on. The heater is ready to use. Press the power switch to the “
O
” position to turn off the power of the
heater.
ON/OFF Button (
)
Press the ON/OFF button, the heater will start operation at high heating power. The high heating
indicator will be on, and the LED display will show the pre-setting temperature 30
∘
C. Press the
ON/OFF button again, the heater will be off in 1 minute.
Mode Button (
)
Press the mode button to change the high heating/low heating/ECO mode during operation, the
indicators will be on according to the selection.
ECO Mode
When the room temperature is lower than 20
∘
C, the high heating mode will be on; when the room
temperature is 20
∘
C or higher than 20
∘
C, the low heating mode will be on.
Temperature Setting (Not applicable in ECO mode)
Press the “+” or “-” button to adjust the temperature with the range of 15-30
〬
C during operation.
The temperature will be added or reduced by 1
〬
C for each press of the “+” or “-” button. After
completing the setting, the display will be flashing for 10 seconds and the set temperature will be
shown.
Note: If the room temperature reaches the set temperature, the heater will be OFF. Once the
room temperature is lower than the set temperature for around 3-4
〬
C, it will be ON again.
