1 / 2
Single-cable Feed System
About This Guide
This document is part of the product.
►
Do not install or use this device until you have read and understood this
document.
►
Perform all operating steps described in this manual in the specified
sequence.
Features
The KEL 4124 single-cable feed system is intended for satellite reception
systems in which up to 24 subscribers are to be supplied. It is designed to
receive Ku-band satellites such as ASTRA, EUTELSAT, Türksat and Hispasat.
Scope of Delivery
■
KEL 4124
■
Instructions for Use
Installation
Safety Instructions
Before installing the feed system, read the safety instructions in the Kathrein
Euroline parabolic antenna user guide.
The safety instructions for parabolic antennae and feed systems are identical.
Installing the Feed System
1. Clamp the feed system between the bottom and the top part of the feed
system mounting and tighten it loosely by means of the screw (Abb. 1).
2. See Abb. 2 for the polarisation setting angle.
3. Set the corresponding angle by turning the feed system.
4. Screw the feed system support firmly in place (Abb. 3).
Connecting the Cable
1. Slide the protective cap onto the cable, Kathrein type LCD 90, LCD
95A+,LCD 111A+ or LCD 115A+.
2. Remove the insulation and screw the F-type connector* (e.g. EMK 01) onto
the end of the cable. Make sure that there is no contact between the wires
of the braided shield and the inner conductor (risk of short circuit).
3. Connect the cable to the feed system.
4. Push down the protective cap as far as it will go on the feed system casing.
*) Not included in the scope of delivery.
Fig. 2
Standpunkt vor der Parabolantenne
Fig. 1
Fig. 3
Fig. 4
KEL 4124
20110031
IMPORT
ANT
Read carefully
before use!
