27
protective clothing.
▪
High-pressure jets can be dangerous if subject to misuse. The jet must not be
directed at persons, live electrical equipment or the appliance itself. Pressure
washers should not be pointed at tire walls, as it may be possible to damage
them.
▪
Do not direct the jet against yourself or others in order to clean clothes or
footwear.
▪
Disconnect from the electrical power supply before carrying out user
maintenance.
▪
To ensure the appliance safety, please use only original spare parts from the
manufacturer or approved by the manufacturer. Do not use the machine
before you changed them if they are damaged.
▪
WARNING:
the warnings, cautions and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that
may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be
supplied by the operator.
▪
Only those persons who are aware of how to use the appliance by having read
this manual, should use the machine. Injudicious use may cause danger.
3.0 PLACING
The Karömat high pressure cleaner is equipped with 4 rubber wheels which allow
the machine to move lightly even on difficult surfaces.
The Karömat high pressure cleaner should be placed always as horizontal as
possible. Do not use the cleaner in an enclosed space and in rooms with danger of
explosion. Take care of sufficient waterdischarge and sufficient air for the burner.
Because of the smoke produced by the burner, the machine should only be used
in open air or in very well ventilated rooms. If the machine is to be connected to a
permanent funnel, place a trapezium shaped cap about 10 cm above the chimney
of the cleaner. Funneldiameter should be at least 18 cm.
Protect the machine in winter against temperatures below zero. Place the cleaner
in a frostfree environment or let antifreeze circulate through the machine.
3.1 ELECTRIC CONNECTION
In the factory the machine is already fully equipped with cables. The machine now
has to be connected to your own electric circuit. Connect the cleaner to a separate
group. Beware that voltage and amperage of your electric circuit meet the needs
of the machine. Therefore check technical details (9.0).
Use only cables with the right diameter. The factory advises to use cables of at
least 4 x 2.5 qmm for the HD 900-150 and the HD 900-200, and a cable of 3 x 2.5
qmm for the HD 600-100.
Never lay the plug and contact cover in water, and never put them in a place
where it can get wet from spraying.
Danger for electrocution!
