2. Make sure the axles are inserted properly. After mounting the axles,
check to be sure
the wheels won't
release without pushing
release button
and insure that the axles are locked in place (
check
the release
buttons extend completely
, rear wheels spin freely
but can't be pulled off), and
two small elastic balls should come out.
3.
Axle Adjustment -
The
axle length has been adjusted at the factory
but it may be readjusted. To adjust begin by removing rear wheel:
Depress rear wheel's center release button and slide the axle out
through the camber.
Use a wrench to hold flats on axle stationary, and use a 3-holes-
wrench (come with the chair) to adjust nut at opposite end.
Street Use
Your wheelchair should not be operated on roads and streets except
when using crosswalks. At such times, use only marked pedestrian
crosswalks and proceed with extreme caution.
Transferring
Never stand on the footrest foot plates while transferring because the
chair may tip over. Always engage the wheel locks before transferring
in or out of your wheelchair.
Wheel Locks
Wheel locks are designed to prevent the rear wheels from turning when
the chair is stopped. It is not intended to slow down the chair when it is
moving. Adjust the wheel locks after making any changes to the rear
axle sleeves position.
When reassembling the wheelchair after removing the rear wheels,
insure that the rear axles are locked in place to prevent wheels from
falling off.
Warning:
Summary of Contents for KM-1500F
Page 2: ......
