27
4.6.2 Adjusting length of seat belt
4.6.2.1 Identify the require length of the belt. (Figure 4.37)
4.6.2.2 Push the two part of belt through buckle to make the belt longer or shorter.
(Figure
4.38)
4.6.2.3 Pull the two part of belt tight. (Figure 4.39)
4.6.2.4 Push buckle up to the plastic clip so that the belt cannot slip out of position.
Please check that there is no gap between the clip and buckle. (Figure 4.40)
WARNING:
● We recommend that the belt is fitted quite tightly around the pelvis. Please
tighten until you can just get your fingers between user and seat belt. Please
check that the belt is fastened correctly as recommended. If this is not
possible please consult your supplier..
Figure 4.37
Figure 4.38
Figure 4.39
Figure 4.40
4.6.3 How to operate it:
4.6.3.1 When you sit on the wheelchair, fasten the pelvic belt.
4.6.3.2 Adjust the belt and make it fit your body for comfort and security.
4.6.3.3 When you don't use it, please fasten the belt to avoid the belt dropping
into rear wheels during motion.
4.6.4 Maintenance
The pelvic belt is made from 100% polyester fiber and the clasp is made from
plastic. It does not require any maintenance but should be inspected every month
to ensure that the edges are not frayed and weekly to make sure that it correctly fits
the user. If there are any signs of deterioration, please replace it immediately.
