41
WARNING:
●
Set the Flexx series at the positions specified in the above sections of
5.3.1, 5.3.2 and 5.3.3.
●
Anti-tippers MUST be equipped to your wheelchair when the axle plate
setting is at Active position mentioned in the Section 5.3.1.
●
Both rear wheels should be set at the same position.
●
Any wheel position change should ONLY be performed by your local
dealers or approved therapists.
5.3.4 Backrest Angle Adjustment.
●
Loosen bolt A and nut C.
●
Adjust the backrest tube to the desired position and angle. (from -4〫to
16〫)
●
Insert bolt A into the new position. Tighten bolt A and nut C with washer
B.
●
Repeat the above procedures on the other side of the chair.
WARNING:
●
Anti-tippers MUST be equipped, when the backrest angle is set as greater
than or equal to four degrees.
