18
4.5 Safety Belt
How to assemble and disassemble the Safety Belt
Loosen the fourth and fifth screws of both side of seat upholstery and insert the
Safety Belt in between the fourth and fifth screw holes. (Figure 4.23.)
Keep the safety Belt in 45 deg for comfortable usage. (Figure 4.24.)
Put the seat upholstery back and tighten screws.
Figure 4.23
Figure 4.24
Adjusting length of seat belt
Identify the require length of the belt. (Figure 4.25.)
Push the two part of belt through buckle to make the belt longer or shorter.
(Figure 4.26.)
Pull the two part of belt tight. (Figure 4.27.)
Push buckle up to the plastic clip so that the belt cannot slip out of position.
Please check that there is no gap between the clip and buckle. (Figure 4.28.)
SUGGESTION:
We recommend that the belt is fitted quite tightly around the pelvis. Please
tighten until you can just get your fingers between user and seat belt. Please
check that the belt is fastened correctly as recommended. If this is not possible
please consult your supplier.
Figure 4.25
Figure 4.26
Figure 4.27
Figure 4.28
How to operate it:
When you sit on the wheelchair, fasten the safety belt.
Adjust the belt and make it fit your body for comfort and security.
When you don’t use it, please fasten the belt to avoid the belt
dropping into rear
wheels during motion.
Summary of Contents for Ergo Lite
Page 1: ...Ergo Lite KM 2501 ...
Page 2: ......
Page 9: ...5 Figure 2 3 Figure 2 4 Figure 2 5 Figure 2 6 Figure 2 7 ...
Page 30: ......
