13
12
13
12
IF YOU BOUGHT THE PASSIVE MODEL BX 7412 or BX 7415:
Connect the speaker to an amplifier using a cable with Speakon connectors. Be sure
that the amplifier you connect to the speaker doesn’t supply an higher power than
the speaker or you will risk to damage it. Woofers and tweeters are not covered by
warranty. You can also buy the same speaker in “amplified” version. This will allow you
to connect and amplify also the passive speaker with the same power.
IF YOU BOUGHT THE POWERED MODEL BX 7412A/ BX 7415A:
•
Be sure that the speaker is switched off with the POWER button (10) in OFF
position and that the power cord (11) is not plugged into the mains socket. All
operations should be carried out without power.
•
Place your speaker in a suitable place, keeping it away from moisture and direct
sun rays. Use the side handles to carry the fixture.
•
Check that the selected (9) voltage is correct. A wrong voltage could seriosly
damage the fixture and cause dangerous short-circuits.
•
You can plug a microphone with XLR connector in the MIC socket (3). If you have
a microphone with 6,3 mono jack connector, you can use the socket (2).
•
The input signal, coming from a mixer, a CD player or another “line” device, can be
connected to the RCA (6), XLR (5) or Jack 3,5mm(18) “line input” sockets.
•
A further output for another powered speaker is available as an audio line signal,
on the “line output” XLR socket (7), while if you want to connect at 8 Ohms a
passive speaker mod. BX 7412 or BX 7415 you can use the speakon (8) socket.
The powered speaker will amplify also the passive one. WARNING: Only one
passive speaker can be connected to socket (8).
•
If you wish to place your speaker on a tripod stand, please use the mount hole on
the bottom. It has a standard 35 mm diameter.
•
Once made the connections, please put all the amplifier volumes at their minimum
position (completely turned anti-clockwise). Connect the power cord to the socket
(11) and then to the mains (230V)
•
Turn on the amplifier through the POWER button (10). The power led (14) will
light up to indicate that the speaker is on. If with the button (10) in ON position the
led (14) remains off and the speaker doesn’t work, before contacting the technical
service, disconnect the power cord and check if the protection fuse of the power
socket (11) is ok. If it is blown replace it with one of the same amperage. During
use, the cooling wings could get very hot. Don’t touch them to avoid the risk of
burning yourself.
•
Turn on the fixture providing the audio signal. The signal will be amplified. The
volume of each amplified signal can be adjusted through the specific control: for
the microphone use the rotating knob (1), for the line signal use the rotating knob
(4). The rotating knob Master (15) controls the general level of the output signal.
ENGLISH
