9
8
IF YOU BOUGHT THE PASSIVE MODEL BX 6822:
Connect the speaker to an amplifier using the correct connector. You can use the
ordinary red/ black plugs(+/-), jack 6,3 and the more professional jack 6,3 mm.
Be sure that the amplifier doesn’t supply an higher power than the speaker or you will
risk to damage it. Woofer and tweeter are not covered by warranty.
IF YOU BOUGHT THE POWERED MODEL BX 6822AB:
•
Be sure that the speaker is switched off with the POWER button (10) in OFF
position and that the power cord (11) is not plugged into the mains socket. All
operations should be carried out without power.
•
Place your speaker in a suitable place, keeping it away from moisture and direct
sun rays. Use the side handles to carry the fixture.
•
Check that the selected (9) voltage is correct. A wrong voltage could seriosly
damage the fixture and cause dangerous short-circuits.
•
You can plug a microphone with XLR connector in the MIC socket (3). If you have
a microphone with 6,3 mono jack connector, you can use the socket (2).
•
The input signal, coming from a mixer, a CD player or another “line” device, can be
connected to the RCA (6) or XLR (5) “line input” sockets.
•
A further output for another powered speaker is available as an audio line signal,
on the “line output” XLR socket (7), while if you want to connect at 8 Ohms a
passive speaker mod. BX 6822 you can use the speakon (8) socket. The powered
speaker will amplify also the passive one.
•
If you wish to place your speaker on a tripod stand, please use the mount hole on
the bottom. It has a standard 35 mm diameter.
•
Once made the connections, please put all the amplifier volumes at their minimum
position (completely turned anti-clockwise). Connect the power cord to the socket
(11) and then to the mains (230V)
•
Turn on the amplifier through the POWER button (10). The power led (14) will light
up to indicate that the speaker is on. If with the button (10) in ON position the led
(14) remains offo and the speaker doesn’t work, before contacting the technical
service, disconnect the power cord and check if the protection fuse of the power
socket (11) is ok. If it is blown replace it with one of the same amperage. During
use, the cooling wings could get very hot. Don’t touch them to avoid the risk of
burning yourself.
•
Turn on the fixture providing the audio signal. The signal will be amplified. The
volume of each amplified signal can be adjusted through the specific control: for
the microphone use the rotating knob (1), for the line signal use the rotating knob
(4). The rotating knob Master (15) controls the general lever of the output signal.
The led CLIP(13) can flash to indicate signal peaks. If it remains on for more than
2 or 3 seconds, you must immediately turn down the volumes of input signals to
ENGLISH
