ASSEMBLY INSTRUCTIONS
2 I 2
USB charger mechanism with idle power supply consumes less than about 0,2W.
The installation must be done by a person with sufficient qualifications, with power supply
disconnected, and must comply with national safety standards.
The connection to the installation should be done as shown in Figure 2. With improper connection, the
charger may be damaged or may work incorrectly.
NOTE!
tightly to do this.
1. Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).
8. Insert the USB charger modules in the intermediary unit.
10. Attach the label and glass pane.
3. Dismantle the USB charger modules (4).
4. Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame
6. Insert the spacer frame in the external frame (6) and snap the entire set on the tabs protruding from
2. Remove the screw (2).
the assembly block.
7. Connect the wires of the installation to the USB charger module as shown in Figure 2.
5. Set the assembly block in the box (9) with tabs or screws at the box (8).
9. Screw down the intermediary unit to the assembly block.
Fig. 1
9
8
7
6
5
4
3
2
1
Fig. 2
