Kargo Master PRO-IV, Assembly Instructions Manual, Page: 4 / 8

G
N
K
SILIC
ONE
STEP 1
STEP 2
#1 = Cover entire swedge joints with silicone
sealant and join FRONT and REAR side channels
together, there is a LEFT & RIGHT FRONT, with
the Right marked with a GREEN dot on the
overlapping plate. There is a RIGHT & LEFT
REAR. The leg cups angle outward. Be sure the
connecting plates overlap, and bolt together with
bolts G , washers K and lock nuts N .
#2 = Slide the FRONT leg onto the front side
channel. There is a RIGHT & a LEFT.
Match to the correct side channel so that both
FRONT & REAR legs angle outward.
Insert the set screws
P , but do not tighten yet.
#3 = Loosely attach the top CLAMP with
bolts F , washers K , and nuts N .
#1 = Cover entire swedge joints with
silicone sealant and attach the REAR LEGS
with bolts
C , washers J , and nuts M .
Note: The distance between front & rear
legs will not be longer than the inside
measurements of the bed itself.
F
P
N
K
STEP 3
SILIC
ON
E
C
J
M
(RIGHT SIDE SHOWN)
Bulkhead Tailgate
#1 = Measure the inside of truck bed, from
tail gate to bulk head. Position the front
legs at approximately that distance from the
rear legs. Final positioning of the front legs
will follow in STEP 7.