Instructions – 406GMF-P
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Page 5
Step 2 – Install Upper Corner Mounts
Along the roof of the van, locate the mount
locations behind both seats. These are above the
slider door.
Evaluate the mounting locations and determine if a threaded emboss is present.
Note: In some vans, a M6 threaded emboss will be attached (see picture above). The others will have two
through holes.
Be sure to use the correct upper corner mount. When the mount is attached properly, the flange should
be towards the front of the vehicle and parallel to the floor. The slots in the upper corner mount will
attach to the partition assembly.
Through the rear most hole of the upper corner mount, attach in place using a M6 x 22mm hex head bolt,
two 1/4” flat washers and a 1/4” lock nut in the orientation shown.
Driver Side Shown Here
