![background image](http://html1.mh-extra.com/html/karcher/windsor-admiral-adm8/windsor-admiral-adm8_operating-instructions-manual_3760281026.webp)
26
Maintenance
Vacuum Motor Replacement
Only qualified maintenance personnel are to
perform the following repairs.
Seul le personnel d'entretien qualifié peut effectuer
des réparations.
1.
Turn off all switches and unplug machine.
2.
Remove recovery tank.
3.
Remove the (2) screws that fasten the solution
tank to the frame, and tilt tank back to expose the
inside of the frame.
4.
Locate the vacuum motor wires and disconnect at
the connector. Close the solution tank.
5.
Remove the (6) screws holding the vacuum motor
cover to the solution tank.
6.
Remove the vacuum motor.
7.
Reverse process to install vacuum motor.
3
8
[9.5 mm]
Carbon
Brushes
End Cap
If armature commutator is grooved, extremely pitted or not
concentric, the motor will need to be replaced or sent to a
qualified service center.
Important:
These brushes wear quicker as the length shortens due to
increased heat. Spring inside brush housing will damage
motor if brushes are allowed to wear away completely.
Periodically check the length of the carbon brushes. Replace
both carbon brushes when either is less than 3/8" (9.5mm)
long.
WARNING:
The green ground wire must be attached for
safe operation. See wiring diagram.
AVERTISSEMENT:
Le fil à la terre vert doit être attaché
pour un fonctionnement en toute sécurité. voir le schéma
de câblage.
86401310 Operators Manual - ADM8 115V