Kärcher V 60/24-2 W, Original Instructions Manual

Page: 7 / 19

– 6
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
1 Handle for filter cleaning
2 Spring
3 Fastener for filter dedusting
4 Suction head cap
 Tilt the fastener for filter dedusting to-
wards the side.
 Unscrew the handle for cleaning the fil-
ter.
 Remove the spring.
 Unscrew the nut below the spring (you
will need a spanner with width 27 mm).
 Open both the suction head caps.
1 Suction head
2 Frame
3 Filter
 Remove the suction hand.
 Open the knot of the tapes on the filter
and remove the frame.
 Take out the filter.
 Insert and secure the new filter in the re-
verse sequence of steps.

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.

DANGER
Have all checks and works on electrical
parts performed by an expert.
No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
Filter, nozzle, suction hose or suction pipe
may be blocked.
 Check, clean the accessories, replace
the filter, if required.
Filter has not been fastened correctly or is
defective.
 Check to see if filter is sitting properly;
replace if required.
Filter is blocked.
 Switch off the appliance, clean the filter
or insert a new filter.
Filter is blocked.
 Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
 Clean filter.
 If a filter cleaning does not lead to suc-
cess, replace the filter.
Changing/ replacing filter
Troubleshooting
Motor (suction turbine) does not
start
Suction capacity decreases slowly
Dust comes out during the
vacuuming
Manometer indicates a negative
suction pressure below -0.16 bar (-
16 kPa)
Indicator lamp "Filter blocked"
glows
17 EN