Kärcher Puzzi 8/1 C, Manual

Page: 13 / 200

– 3
 Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Note: When cleaning previously sham-
pooed carpets, foam is generated in the
wastewater container. This formation of
foam can be prevented by adding a de-
foaming agent.
 Put defoaming agent (optional accesso-
ry) into the wastewater container.
 Plug in the mains plug.
 Press the suction switch to turn on the
suction turbine.
 Press the spray switch to switch on the
spray pump.
ATTENTION
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
 Operate the lever on the manifold in or-
der to spray the cleaning solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
 In case of work interruptions, the floor
nozzle can be stored in the carrying
handle of the device.
 When changing nozzles, the hand noz-
zle (not included in the scope of deliv-
ery) can be inserted into the accesso-
ries holder.
 Switch off the spray and suction switch-
es.
 Pull out the mains plug.
 If the dirt water reservoir is full, switch
off the suction and spray switches.
 Remove the lid.
 Remove the wastewater container from
the appliance and drain it.
 Turn off the appliance.
 Shortly activate the lever on bender to
decrease the pressure.
 Separate bender from the spray/suction
hose.
 Insert the suction hose into the fresh
water reservoir.
 Press the suction switch to turn on the
suction turbine.
 Empty the fresh water reservoir and
switch the appliance off.
 Remove the lid.
 Remove the wastewater container from
the appliance and drain it.
 Connect the elbow (with suction pipe
and floor nozzle) to the suction hose.
 Connect the coupling of the spray hose
with the manifold and snap in place.
 Fill approx. 2 litres of fresh water into
the fresh water reservoir.
Do not add any detergents.
 Press the spray switch to switch on the
spray pump.
 Place floor nozzle into the waste water
container.
 Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
 Turn off the appliance.
 Remove the wastewater container from
the appliance and drain it.
 Flush appliance.
 Empty the wastewater container and
clean it under running water.
 Empty the fresh water reservoir.
 Clean the outside of the appliance with
a damp cloth.
Fill up fresh water reservoir
Defoaming agent
Operation
Turning on the Appliance
Cleaning
Turn off the appliance
Empty wastewater container
Empty the fresh water reservoir
Flush appliance
After each operation
13 EN