3
English
Safety Instructions
ATTENTION!
Do not use the appliance without having
read the instructions for use.
Please observe the safety instructions of
your high-pressure cleaner.
The Powerscrubber must not be used by
children.
Only trigger the high-pressure jet if the
Powerscrubber is located on the surface
to be cleaned.
Beware of the backstroke! Ensure a stable
position and firmly hold the high-pressure
gun with the extension tube.
There must be no persons in the
immediate vicinity of the cleaning head.
Turn off the high-pressure cleaner during
all works at the Powerscrubber and after
the completion of the cleaning operation.
Maximum water temperature 60°C (please
observe the instructions of your high-
pressure cleaner).
Description of the unit
Powerscrubber with
scratch edge
Extension tube
Extension tube with union nut/handle
The Powerscrubber can be used with all
Kärcher high-pressure cleaners from the
model year 1992 and later, up to a pressure
of 16 Mpa (160 bar / 2300 psi).
The Powerscrubber is ideally suited for the
high-pressure cleaning and scrubbing of
smooth floor surfaces outside (e.g. wooden
or stone floors, clinker, tiles, concrete) as well
as of floor surfaces with a water discharge
inside (e.g. wash-room, garage). The built-in
scratch edge can be used to remove stubborn
dirt.
Use the Powerscrubber exclusively in your
private household.
Assembly
1. Screw the extension tube
until the stop
on the thread of the Powerscrubber.
2. Connect the extension tube
with the
extension tube
.
3. Press the extension tube
into the bayonet
connection of the high-pressure gun, then
turn by 90° until it locks into place.
4. Firmly turn the union nut on the high-pressure
gun.
Note:
In the unpressurised state the extension
tube can be aligned to the Powerscrubber. In
the high-pressure mode the extension tube is
fixed.
Removing the nozzles
Note
: The nozzles must be removed for
cleaning or for the exchange of the nozzles.
1. Remove the clip.
2. Pull out nozzle and filter.
3. Clean the filter.
4. Insert the nozzle with the filter.
5. Re-insert the clip.