Kärcher KM 100/100 R P, Instruction Manual

Page: 12 / 18

-
10
The sweeping track should have an even
rectangular shape which is between 50 and
70 mm wide.
Note: The side brush floating mounting of
the roller brush adjusts the sweeping track
as the bristles wear down. The roller brush
must be replaced if it becomes too worn.
 Park the sweeper on an even surface.
 Set programme switch to step 1 (driv-
ing). Roller brush is raised.
 Turn main key to "0" and remove it.
 Secure the machine with wheel
chock(s) to prevent it from rolling away.
 Raise slightly the waste containers on
both sides and pull them out.
 Open the fastening screws of the side
panels on both sides.
 Remove side panels.
 Front sealing strip
 Slightly loosen retaining nuts for the
front sealing strip; to replace, unscrew.
 Screw on new sealing strip without fully
tightening the nuts.
 Adjust sealing strip.

Set the distance of the sealing strip to
the floor so that the bottom edge trails
behind at a distance of between 35 and
40 mm.
 Tighten nuts.
 Rear sealing strip
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.
 If worn, replace.
 Remove roller brush.
 Unscrew retaining nuts for rear sealing
strip.
 Screw on new sealing strip.
 Side sealing strips
 Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).
 Screw on new sealing strip without fully
tightening the nuts.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.

Tighten nuts.

Screw on side panels.
 Push in the waste containers on both
the sides and lock them.
몇
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Turn main key to "0" and remove it.
 Open the hood, insert retaining rod.
 Pull out the filter holder to the maximum
possible extent and lock.
 Remove the lamella filter.
 Insert new filter.
 Make sure driver engages with holes on
drive side.
 Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.
 Lift filter case seal out of groove in the
cover.
 Insert new seal.
Adjusting and replacing sealing strips
Replacing dust filter
Replacing filter case seal
12 EN