Kärcher KHD 4 L, Manual

Page: 14 / 84

14 English
몇 CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
Prior to extended storage periods, as during the winter,
also observe the instructions in the Care section.
 Park the machine on an even surface.
 Push the casing of the quick coupling for the high
pressure hose toward the rear and disconnect the
high pressure hose from the appliance.
 Push the disconnect button on the trigger gun and
pull the high-pressure hose out of the trigger gun.
 Place the trigger gun into the storage for the trigger
gun.
 Engage the spray lance in its holder.
 Suspend the high-pressure hose into its holder.
Illustration
 Stow the power cord and the remaining accesso-
ries on the appliance.
ATTENTION
Appliances and accessories that are not completely
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
To avoid damage:
 Completely drain all water from the appliance:
Switch the appliance on with detached high pres-
sure hose and detached water supply (max. 1 min-
ute) and wait, until no more water exits at the high
pressure connection. Turn off the appliance.
 Store the appliance and the entire accessories in a
frost free room.

DANGER
Risk of electric shock.
 Prior to all work on the appliance, switch off the ap-
pliance and pull the power plug.
Clean the sieve in the water connection regularly.
ATTENTION
The sieve must not be damaged.
 Remove coupling from the water connection.
Illustration
 Pull the sieve out (e.g. using flat pliers), clean un-
der running water and then reinsert it.
Prior to longer periods of storage, e.g. in the winter:
 Remove filter from suction hose for detergent and
clean under running water.
You can rectify minor faults yourself with the help of the
following overview.
If in doubt, please consult the authorized customer ser-
vice.
 DANGER
Risk of electric shock.
 Prior to all work on the appliance, switch off the ap-
pliance and pull the power plug.
 Push the lever of the trigger gun, the device will
switch on.
 Check whether the voltage indicated on the type
plate corresponds to the voltage of the mains sup-
ply.
 Check the mains connection cable for damages.
 Check water supply for adequate delivery rate.
 Pull out the sieve in the water connection using flat-
nose pliers and clean under running water.
 Appliance ventilation: Switch the appliance on with
the high-pressure hose detached and operate
(max. 2 minutes) until the water exits the high-pres-
sure connection without bubbles. Switch off appli-
ance and reconnect high-pressure hose.
 Clean high-pressure nozzle: Remove dirt and de-
bris from the nozzle bore, using a needle and rinse
through with water from the front.
 Check water flow quantity.
 Slight leakage from the appliance pump is normal.
If the leakage increases contact the authorized
customer service.
 Check the detergent suction hose for kinks.
The warranty terms published by our competent sales
company are applicable in each country. We will repair
potential failures of the appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in fabrication.
In a warranty case, please contact your dealer with the
purchase receipt and the item number
(IAN 351642) or
the next authorised customer service site.
Addresses can be found under:
www.kaercher.com/dealersearch
Storage
Storing the Appliance
Frost protection
Care and maintenance
Clean the sieve in the water connection
Cleaning the detergent filter
Troubleshooting
Appliance is not running
Pressure does not build up in the appliance
Strong pressure fluctuations
Appliance is leaking
No detergent infeed
Warranty