Kärcher K 6.200, Manual

Page: 19 / 244

– 10
Caution
Protect the appliance and its accessories
against frost.
The appliance and its accessories can get
destroyed through frost if there are any wa-
ter residues in them. To avoid damage to
them:
 Completely drain all water from the ap-
pliance: Switch the appliance on with
detached high pressure hose and de-
tached water supply (max. 1 minute)
and wait, until no more water exits at the
high pressure connection. Turn off the
appliance.

Store the appliance and the entire ac-
cessories in a frost free room.

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Prior to longer periods of storage, e.g. in
the winter:
 Remove filter from suction hose for de-
tergent and clean under running water.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
The appliance is maintenance free.
Use only original KÄRCHER spare parts.
You will find a list of spare parts at the end
of these operating instructions.
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.

Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.

Check the mains connection cable for
damages.
 Release the lever of the hand spray
gun; the appliance will switch on.
 Check setting at the spray lance.
 Appliance ventilation.
Switch on the appliance without con-
nection the high-pressure hose (max. 2
minutes) and run it until the water dis-
charging from the high-pressure outlet
is free of bubbles. Switch off appliance
and reconnect high-pressure hose.
 Check the water supply.
 Pull out the fine filter in water connec-
tion using flat-nose pliers and clean with
running water.
Cause: Voltage reduction due to weak
mains supply or when using an extension
cable
.
 When switching on, first pull the lever of
the trigger gun and then switch the ap-
pliance switch to "I/ON".
Frost protection
Maintenance and care
Care
Maintenance
Spare parts
Troubleshooting
Appliance is not running
Pressure does not build up in the
appliance
Appliance does not start, motor
hums
19 EN