-
4
Illustrations on fold-out page!
1
Coupling element for water
connection
2
Water connection with integrated sieve
3
Appliance switch "0/OFF“/ „I/ON“
4
High pressure hose
5
Dosage regulator for detergent
6
Storage for trigger gun
7
High-pressure hose drum
8
Transport handle
9
Hand crank for hose drum
10 Storage of detergent reservoir with deter-
gent connection
11 Storage for accessories
12 Storage hook for mains connection cable
13 Mains cable with mains plug
14 Detergent reservoir with locking lid
15 Wheels
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high-pressure hose
from the trigger gun
19 Spray lance with pressure regulation
(Vario Power)
20 Spray lance with Dirtblaster
21 Washing brush
22 Rotary washing brush
23 Delta-Racer D150
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Push the wheels into the intake and se-
cure them with the plugs. Align the plug
properly.
Illustration
Place the bottom holder into the recesses
and push forward until it audibly lcoks in.
Insert the top holder and push down all
the way.
Illustration
Press in the storage hook and lock it into
the top position.
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Slide the transport handle into the guide
and secure it with 2 screws.
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose
fittings.
Install the dosage regulator and connect
using 2 screws.
Note
: During installation you must make
sure that the tongues of the dosage regu-
lator match up with the intended recesses
in the casing.
Illustration
Slide the free end of the coiled high pres-
sure hose through the recesses on the
dosage regulator.
Insert the hose drum into the intakes on
the transport handle.
Insert the axle of the hand crank into the
guides.
Install the fixating plate and secure it us-
ing 2 screws.
Press the connecting fitting from the short
high pressure hose into the brass intake,
secure with clamps.
Note:
Make sure the connection nipple is
aligned correctly.
Illustration
Push the high pressure hose into the trig-
ger gun until it locks audibly.
Note:
Make sure the connection nipple is
aligned correctly.
Special accessories
Before Startup
Install wheels
Install the storage for hand-spray gun
Install the storage hook for the mains
connection cable
Install the transport handle
Install the dosage regulator for deter-
gent
Install the high pressure hose drum
Connect the high pressure hose to the
hand spray gun
!
"#
