Kärcher K 3.800 eco!ogic, Manual

Page: 16 / 244

– 7

Connect the water supply hose to the
water supply.
 Completely open the water tap.
Note: The max. suction height is 0.5 m.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
 Fill the suction hose with water.
 Figure
Screw the suction hose into the water
connection of the appliance and insert it
into the water source (e.g. rainwater
drum).
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
 Insert the mains plug into the socket.
 Set the appliance switch to "1/ON".
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Switch the appliance on for a (max. of 2
minutes) and wait until the water exits at
the hand spray gun without bubbles.
 Release the lever on the trigger gun.
 Set the appliance switch to "0/OFF“.
Caution
Prior to cleaning, make sure that the high
pressure is placed safely on level ground.
Wear protective goggles and protective
clothing during the cleaning process.
 Illustration
Push the spray lance into the trigger gun
and fasten it by turning it through 90°.
 Set the appliance switch to "1/ON".
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure
that you have a firm footing and are also hold-
ing the trigger gun and spray lance firmly.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max".
 Release the lever on the trigger gun.
 Turn the spray lance to the desired po-
sition.
–
Suitable for working in switch position
"eco".
Note : Suitable for working with detergent;
for this, turn the spray lance to the "Mix" po-
sition.
For particularly dirty items or areas.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
–
Not suitable for use with detergents.
–
Not suitable for working in switch posi-
tion "eco".
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
 Illustration
Pull detergent suction hose as far as is
required out of the housing.
Suspend end of detergent suction hose
in a container filled with detergent.
 Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
Drawing in water from open reservoirs
Start up
Operation
Spray lance with pressure regulation
Spray lance with Dirtblaster
Working with detergent
16 EN