– 5
The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
Illustrations on the picture pages
1
High pressure connection
2
Appliance switch „0/OFF“ / „I/ON“
3
Storage hook
4
Carrying handle
5
Transport handle, detachable
6
Storage for spray lance
7
Storage for trigger gun
8
Water connection with integrated sieve
9
Coupling element for water connection
10 Mains cable with mains plug
11 Bearing wheel
12 Trigger gun
13 Lock trigger gun
14 Clamp for high pressure hose
15 High pressure hose
16 Full Control spray lance Dirtblaster
For strong contaminations.
Pressure level: HARD
17 Full Control spray lance Click-Vario Power
Carrying out the most common cleaning tasks.
Pressure levels: HARD / MEDIUM / SOFT / MIX
Illustrations on the picture pages
Illustrations
-
Mount loose parts delivered with appliance prior to
start-up.
Park the appliance on an even surface.
Illustrations
-
Pull out the clamp from the trigger gun and plug the
high-pressure hose into the trigger gun.
Push the clamp in until it locks. Check the secure
connection by pulling on the high-pressure hose.
Illustrations
-
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories. For protection, the use of
the KÄRCHER water filter (optional accessory, order
no. 4.730-059) is recommended.
몇
CAUTION
Dry running of more than 2 minutes leads to damage of
the high-pressure pump. If the appliance does not build
up pressure within 2 minutes, switch the appliance off
and proceed in accordance with the instructions in
Chapter "Troubleshooting".
몇
CAUTION
Keep a distance of at least 30 cm when using the jet for
cleaning painted surfaces to avoid damage.
ATTENTION
Car tyres, paint or sensitive surfaces such as wood
should not be cleaned with the dirt blaster, as there is a
risk of damage.
Illustrations
-
ATTENTION
The sensitivity of the materials can strongly differ de-
pending on the age and the condition. The so-called
recommendations are non-binding.
Note:
Detergent can only be added when the device is
operated in low pressure mode.
Optional
Illustrations
-
Illustration
Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
Spray off loosened dirt with the high pressure jet.
After operation with detergent: Run the machine for
approximately 1 minute for a clear rinse.
Description of the Appliance
* Optional
18 Washing brush
Suitable for use with detergents.
19 Foam nozzle
For effective detergent foam.
20 Detergent
21 Detergent suction hose (with sieve)
** Additionally required
22 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
Installation and Startup
Operation
High pressure operation
Full Control System
Pressure level
For example, recommended for
HARD
Stone terraces made of paving
stones or exposed aggregate con-
crete, asphalt, metal surfaces, gar-
den utensils (wheelbarrow, spade,
etc.)
Turn the Full Control spray lance Click-Vario
Power as far as it will go for maximum possi-
ble pressure.
MEDIUM
Motorcar / motorcycle, brick sur-
faces, plastered walls, plastic furni-
ture
SOFT
Wooden surfaces, bicycles, sand
stone surfaces, rattan furniture
MIX
Operation with detergent
Operation with detergent
Recommended cleaning method
After operation with detergent
9
EN