Kärcher K 2.325, Operating Instructions Manual

Page: 8 / 16

8 English
STEP 4:
 Connect the high pressure nozzle and
press the hand trigger to begin clean-
ing.
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Illustration
 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Illustration
 Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Completely open the water tap.
 Insert the mains plug into the socket.
 Turn on the appliance “I/ON”.
몇
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure
that you have a firm footing and are also hold-
ing the trigger gun and spray lance firmly.
Illustration
 Unlock the lever on the trigger gun.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
For particularly dirty items or areas.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
Not suitable for use with detergents.
Carrying out the most common cleaning
tasks. The work pressure can be stageless-
ly regulated between "Min" and "Max". You
can add detergent when "Mix" is selected.
 Release the lever on the trigger gun.
Illustration
 Turn the spray lance to the desired po-
sition.
Suitable for use with detergents.
Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
 Detach spray lance from the trigger
gun. Work only with the trigger gun.
Note: This will mix the detergent with
the water stream.
Illustration
 Pull detergent suction hose as far as is
required out of the housing.
 Suspend end of detergent suction hose
in a container filled with detergent.
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.
Start up
Operation
Spray lance with Dirtblaster
Spray lance with pressure regulation
(Vario Power)
Washing brush
Working with detergent
Recommended cleaning method