Kärcher K 2.16, Operating Instructions Manual

Page: 4 / 12

4
English
Caution
„ Observe a distance of at least 30 cm
when using the jet to clean painted sur-
faces to avoid damaging paintwork.
„
Never leave the appliance unattended
when it is in operation.
„ Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
„ All current-conducting parts in the work-
ing area must be protected against jet
water.
„ The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
„ The appliance may only be connected
to alternating current. The voltage must
correspond with the type plate on the
appliance.
„
For safety reasons, we recommend that
you operate the appliance only via a earth-
leakage circuit breaker (max. 30 mA).
„ Do not operate the appliance at temper-
atures below 0 °C.
„ Cleaning operations which produce oily
waste water, e.g. engine washes, un-
derbody washes, may only be carried
out using washing stations equipped
with an oil separator.
„ This appliance was designed to be
used with detergents which are sup-
plied or recommended by the manufac-
turer. The use of other detergents or
chemicals may compromise the safety
of the appliance.
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
These operating instructions describe the
maximum equipment. Depending on the
model, there are differences in the scopes
of delivery (see packaging).
Illustrations on Page 5
1 Coupling element for water connection
2 Connection for water supply with filter
3 Detergent suction hose (with filter)
4 High pressure connection
5 Connection for detergent suction hose
6 Storage for spray lance
7 VELCRO
®
fastener
8 Mains cable with mains plug
9 Appliance switch "0/OFF“/ „I/ON“
10 Trigger gun
11 Lock trigger gun
12 High pressure hose
13 Clamp for high pressure hose
14 Washing brush
15 Spray lance with high pressure nozzle
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Mount loose parts delivered with appliance
prior to start-up.
Illustration
Î Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. a small
screwdriver).
Illustration
Î Hochdruckschlauch in Handspritzpis-
tole stecken.
Î Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Î
Check the secure connection by pulling
on the high-pressure hose.
Î Illustration
Fix the VELCRO
®
fastener to the appli-
ance.
Operation
Scope of delivery
Description of the Appliance
Special accessories
Before Startup