Kärcher IVR-B 20/6, Manual

Page: 7 / 24

English 7
Operation
Starting operation
For the figures, please refer to the
graphics page
1. Plug the mains plug into the socket.
2. Set the power switch to "ON" posi-
tion.
Illustration C
The device is switched on.
3. Start vacuuming.
Emptying the container
For the figures, please refer to the
graphics page
1. Set the power switch to "OFF" posi-
tion.
The device is switched off.
2. Pull the mains plug out of the socket.
3. Unlock the locking clip.
4. Remove the container lid and put it
to one side.
Illustration D
5. Remove the suction hose from the
suction hose connection.
6. Remove the container from the base
plate.
7. Empty the container.
8. Dispose of or reuse the contents in
accordance with statutory provi-
sions.
9. Place the container on the base
plate.
10.Insert the suction hose into the suc-
tion hose connection.
11.Replace the lid on the container and
check it for a correct fit.
12.Lock the locking clip.
Cleaning the container
1. Empty the container (see chapter
Emptying the container).
2. Remove deposits from the contain-
er.
3. Dispose of the deposits in accord-
ance with statutory provisions.
Note
The container can be cleaned wet. Do
not use a high-pressure cleaner for
cleaning. Allow the container to dry af-
ter cleaning.
Finishing operation
1. Set the power switch to "OFF" posi-
tion.
The device is switched off.
2. Pull the mains plug out of the socket.
3. Empty and clean the container (see
chapter Cleaning the container).
Transport
몇
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transport and storage.
1. When transporting in vehicles, se-
cure the device against slipping and
tipping over according to the appli-
cable guidelines.
Storage
몇
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transport and storage.
1. Store the device indoors only.
Care and service
Removing the cartridge filter
1. Remove the nut.
2. Remove the cartridge filter.
3. Replace the cartridge filter.
4. Tight the nut by hand.
Note
Ensure that the filter has been inserted
correctly.
Troubleshooting guide

DANGER
Risk of electric shock
Injuries due to touching live parts