7
4.7
Connecting the water
·
See technical data, chap. 3 for connected
loads.
·
Attach the supply hose to the appliance and to
the water line. The supply hose is not included
in standard delivery.
·
If you draw in the water from an open tank,
you should
– disconnect the water supply from the pump
head
– unscrew the upper supply hose from the
water tank and connect to the pump head.
– use a water supply hose which has a
minimum diameter of 3/4" and a suction
filter.
·
Until the pump has drawn in the water, you
should:
– rotate the pressure and volume control to
“MAX”,
– close the detergent metering valve.
4.8
Connecting the power
·
See technical data, chap. 3 for connected
loads
·
The voltage stated on the rating plate must
correspond to the voltage of the power source.
·
The electric plug must only be fitted by an
authorized customer service/electrical
engineer. The direction of rotation of the engine
must also be observed. If the direction of
rotation is correct, there will be a powerful air
flow from the exhaust gas opening of the
burner.
·
First, position the appliance switch to “STOP”
and then put the electric plug into the socket.
·
If you are using an extension lead, it should
always be completely unwound from the cable
drum and have an adequate cross-section
(25 ft = 12 AWG, 50 ft = 10 AWG).
4. Start-up
4.9
Intended use
·
Use the appliance to clean machines, vehicles,
buildings, tools, etc.
·
Clean facades, patios, garden implements, etc.
with the high-pressure spray only, i.e. without
detergent. We recommend the dirt blaster, a
special accessory, for stubborn dirt.
·
If the machine is used at petrol stations or in
other hazardous areas, the appropriate safety
regulations must be observed.
·
Please ensure waste water containing mineral
oil does not contaminate soil, lakes and rivers or
the sewerage system. Therefore, please wash
engines and underbodies only in appropriate
washing installations provided with oil traps.