![background image](http://html1.mh-extra.com/html/karcher/hds-6-10-c-cx/hds-6-10-c-cx_instructions-manual_654100028.webp)
– 4
–
The safety valve opens, when the over-
flow valve resp. the pressure switch is
broken.
The safety valve is set by the manufacturer
and sealed. Setting only by customer ser-
vice.
–
The water shortage safeguard prevents
the burner to be turned on when there is
water shortage.
–
A sieve prevents the contamination of
the safeguard and must be cleaned reg-
ulary.
–
The temperature stop switches off the
machine when the waste gases have
reached very high temperatures.
몇
Warning
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
Lock parking brake.
Figure 3
Screw tightening torque: 6.5-7.0 Nm
Figure 4
Hook the tool bag onto the top tabs on
the appliance.
Tilt the tool bag down and lock it into
place.
Fasten the tool bag with 2 screws
(torque: 6.5 - 7.0 Nm).
Note:
2 screws are left over.
Figure 5
Hook the hose drum onto the bottom
tabs on the appliance.
Tilt the hose drum up and lock it into
place.
Fasten the hose drum with 4 screws
(torque: 6.5 - 7.0 Nm).
Connect the connecting hose of the
hose drum to the high pressure connec-
tion point of the appliance.
Figure 6
Connect ray tube with hand spray gun
Tighten the screw connection of the
spray lance fingertight.
Insert high pressure nozzle into cover-
ing nut
Install covering nut and tighten firmly
Appliance without hose drum:
Connect the high pressure hose to the
high pressure connection point of the
machine.
Device with hose drum:
Connect high pressure hose to hand
spray gun
Caution
Always unwind high pressure hose com-
pletely
Figure 7
Figure 8
Completely roll off the high-pressure
hose from the hose drum.
Unlatch the fastening clamp for the
high-pressure hose and pull the hose
out.
Slide the hose nipple all the way into the
knot section of the hose drum and se-
cure with the fastening clamp.
Safety valve
Water shortage safeguard
Temperature stop for exhaust gases
Start up
Installing the handle
Install the tool bag (HDS C only)
Install the hose drum (HDS CX only)
Install the hand-spray gun, the jet
pipe, the nozzle and the high
pressure hose
Installing spare high pressure hose
Unit without hose drum
Device with hose drum
28
EN
Summary of Contents for HDS 6/10 C/CX
