9.800-103.0 - B • Karcher HDS 615-617
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
8
ASSEMBLY INSTRUCTIONS
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 2: Remove Wand end and
first place the O-ring followed by
the high pressure nozzle as shown.
Replace end of wand.
STEP 3: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe
oil level in oil window (if equipped).
Use 30 wt. non detergent oil.
Garden
Hose
Spray
Gun
High Pressure
Hose
Wand
High Pressure
Nozzle
O-Ring
STEP 4: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
STEP 5: Connect garden hose to
the cold water source.
STEP 6: Check inlet filters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
22mm
Coupler
Water
Inlet
BATTERY INSTALLATION
SHIELD
EYES
EXPLOSIVE
GASES
CAN CAUSE
BLINDNESS OR INJURY
NO
SPARKS
FLAMES
SMOKING
SULFURIC
ACID
CAN CAUSE
BLINDNESS OR
SEVERE BURNS
FLUSH EYES
IMMEDIATELY
WITH WATER
GET
MEDICAL
HELP
FAST
KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.
DANGER/POISON
Black - Negative
Terminal
Red + Positive
Terminal
98001030-8
Due to Federal Regulations concerning shipment of
corrosive chemicals, batteries are not shipped with
this machine.
Local purchase of battery will be the responsibility of
the owner. Automotive type 12 Volt Group 24 battery
is recommended for placement within the weather
resistant box. Follow safety and installation instruc-
tions furnished with the battery.
Red Cable is attached to battery (+) positive termi-
nal, black cable is connected to battery (-) negative
terminal.