![background image](http://html1.mh-extra.com/html/karcher/hd3-0-27-gb/hd3-0-27-gb_operators-manual_4131216008.webp)
9.801-759.0 - B - Operator's Manual, Catch Up
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
8
STEP 1:
Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 4:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 5:
Connect the high pressure
hose to the discharge nipple. Push
coupler collar forward until secure.
STEP 2:
Attach wand to spray gun
using teflon tape on wand threads.
STEP 3:
Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STEP 6:
Connect garden hose to
the cold water source.
STEPS 8 and 9 for Electric Start Machines Only
( HD 4.0/40 Ge and HD 4.0/40 GeB)
ASSEMBLY INSTRUCTIONS
STEP 7:
Check inlets filters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
STEP 8:
Place battery in battery box. Use a 12 V battery
with a minimum capacity of 24AH.
STEP 9:
To reduce the possibility of sparking attach the
wires to the battery in the following order.Refere to
image aside. First attach the red wire to the positive “+"
terminal of battery and the black wire to the negative
“-" terminal of the battery.To disconnect the battery
remove the wires in the opposite order as installed.
Install battery box cover and fasten in place.
Safety
Latch
Spray
Gun
High
Pressure Hose
Wand
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Box Strap
Battery
Box Lid
Red Wire From the
motor starter
12 Volt
Battery
Battery
Terminal
Battery Box
Black Wire From
ground
Summary of Contents for HD3.0/27 GB
Page 2: ......