HD • 9.807-622.0 • Rev. 03/20
7
PRESSURE WASHER
OPERATOR’S MANUAL
STEP 1:
Attach the handle to the
frame of the pressure washer.
Note
: It may be necessary to move
the handle supports from side to
side in order to align the handle so it
will slide over the frame supports.
STEP 2:
Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3:
Attach the spray gun/hose
storage handle and bracket to
handle. Tighten nuts.
STEP 4:
Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 7:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8:
Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
STEP 5:
Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 6:
Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
STEP 9:
Connect (7.5m) garden
hose to the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 10:
Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
Frame
Assy.
Carriage
Bolt
Nut
Studs
Nut
Hose/Gun
Storage
Bracket
Safety
Latch
Spray
Gun
High
Pressure Hose
Nozzle Extension
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Pump
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Bolts
