Kärcher HD 2.3/15 C Ed, User Manual

Page: 7 / 13

English
7
Protection of the
environment, disposal
The packaging material can be
recycled. Please do not place the
packaging into the ordinary refu-
se for disposal, but arrange for
the proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper re-
cycling of old appliances. Batte-
ries, oil, and similar substances
must not enter the environment.
Please dispose of your old ap-
pliances using appropriate col-
lection systems.
Preparing the unit for use
Unpack the unit
– When unpacking the unit, check the con-
tents of the packaging. If there has been
any damage in transit inform the dealer.
– Do not dispose of the packaging with the
household rubbish, hand it in at the appro-
priate collection point for recycling.
Check the oil level
„
Read the oil level displayed while unit is at
a standstill. The oil level must be above the
two indicators.
Activate the oil reservoir vent
„
Unscrew the fastening screw of the hood
and remove the hood.
„
Cut off the tip on the cover to the oil reservoir.
„
Fasten the unit cover.
Mount the accessories
„
Mount nozzle on the spray lance (see
markings on the top of the setting ring).
„
Fit the spray lance to the hand-held spray gun.
For appliances without hose reel:
„
Undo push-handle clamps.
„
Adjust push-handle to required height.
„
Tighten push-handle clamps.
„
Screw on high-pressure hose to the high-
pressure outlet.
For appliances with hose reel:
„
Insert the crank handle in the hose reel
shaft, until it snaps into position.
„
It is advisable to lay the high-pressure hose
out in a straight line before reeling it up.
„
Wind the high-pressure hose up in even layers
on the hose reel by turning the crank handle.
Select the rotational direction so that the high-
pressure hose does not kink.
Switching on the unit
Electrical connection
Caution!
The voltage specified on the model rat-
ing plate must correspond to the voltage sup-
plied.
Caution!
Use an extension cable with a sufficient
cable cross-section (see Technical Specifica-
tions) and unwind it fully from the cable drum.
For connected loads see model rating plate/
Technical Specifications.
Caution!
It is essential that the unit is connected
to the power supply by means of a plug. An in-
separable connection to the power supply is
prohibited. The plug is used to disconnect
from the mains.