Service Manual Dual Mister Cart 9.808-257.0 - A
PRESSURE
W
ASHER
SER
VICE MANU
AL
6
STEP 1: Open lid and fill solution
tank with disinfectant.
STEP 5: Start up the machine.
STEP 4: Connect to a dedicated
20amp circuit. Push reset button
on GFCI.
CAUTION: Do not use extension
cord. Use only Factory supplied
power cord.
STEP 8: Atach misting nozzle into
the spray gun.
STEP 6: Close metering valve to
purge hose.
STEP 9: Open metering valve to use
Misting mode.
CAUTION: If valve stays close in
misting mode nozzle may get
damage.
STEP 2: Be sure 3 way valve is in
the correct position
CAUTION: Do not run the pump
without water or pump damage
will result.
STEP 7: Purge any air trapped in
hose (Recommended to do this over
solution tank).
STEP 10: Ready to use, mist Vital
Oxide disinfectant.
STEP 11: It is possible to operate
two guns on mist mode at the same
time.
OPERATING INSTRUCTIONS FOR MISTING MODE
STEP 3: Attach the high pressure
hose to the spray gun.
Safety
Latch
Spray
Gun
High
Pressure Hose
IMPORTANT: Do not allow the
machine to run in bypass for
more than 10 minutes at any
one time or damage to pump
may occur.
IMPORTANT: The use of a
backflow preventer on the water
supply hose is recommended
and may be required by local
code.
